|
Description
Professional microprocessor-controlled battery charger and jump starter for 12 V and 24 V batteries. Simply connect the battery, select the required charging mode, and the intelligent charging technology automatically controls the rest of the charging process.
The fully automatic 10-stage charging process combines battery diagnosis, charging, recovery and maintenance charging. The charger is suitable for PB, GEL, AGM, MF and WET batteries with capacities from 20 to 450 Ah.
An integrated recovery function can be activated at battery voltages as low as 1.5 V and is designed to attempt charging of heavily or deeply discharged batteries.
The unit also features a genuine jump-start function with a starting current of up to 200 A. This makes it suitable for professional workshop use as well as cars, vans, agricultural machinery and other vehicles with 12 V or 24 V electrical systems.
The LED display shows important information during charging, including charging voltage in volts, charging current in amperes and charging status as a percentage.
Features
- Intelligent microprocessor-controlled battery charger
- For 12 V and 24 V batteries
- Fully automatic 10-stage charging process
- Charging current: 5 / 15 / 30 / 40 A
- Suitable for battery capacities from 20 to 450 Ah
- Supports PB, GEL, AGM, MF and WET batteries
- Battery diagnostic function
- Recovery function for deeply discharged batteries
- Recovery function can be activated at battery voltages down to 1.5 V
- Automatic maintenance charging
- Battery can be charged while installed in the vehicle
- Jump-start function with up to 200 A
- LED display
- Displays charging voltage, charging current and charging status
- Overload protection
- Short-circuit protection
- Overheating protection
- Reverse polarity protection
- Protection against sparking during connection
- Insulated battery clamps
- Mobile construction
Battery Types
| PB |
Lead-acid battery |
| GEL |
Gel battery |
| AGM |
AGM (Absorbent Glass Mat) battery, commonly used in start-stop systems |
| MF |
Maintenance-free lead-acid battery |
| WET |
Conventional wet-cell lead-acid battery |
Practical Information
The charger can be used directly with a battery installed in the vehicle. The automatic control system monitors the charging process and switches between the relevant stages of the charging cycle.
The jump-start function provides up to 200 A and is designed to assist with engine starting. According to the technical specifications, the function can be used with 35-50 Ah batteries without pre-charging and 65-100 Ah batteries after pre-charging.
The recovery function is designed to attempt charging of heavily or deeply discharged batteries. However, a damaged or defective battery cannot necessarily be restored by charging.
Technical Data
| Supply voltage |
230 V |
| Frequency |
50 Hz |
| Output voltage |
12 / 24 V |
| Minimum mains fuse |
16 A, slow-blow |
| Max. power |
6000 W |
| Charging current |
5 / 15 / 30 / 40 A |
| Battery capacity |
20-450 Ah |
| Jump-start current at 1.5 V |
200 A |
| Jump start without pre-charging |
35-50 Ah |
| Jump start with pre-charging |
65-100 Ah |
| Number of fuses |
10 pcs. |
| Fuse |
50 A |
| Length |
297 mm |
| Width |
295 mm |
| Height |
670 mm |
| Net weight |
16.5 kg |
| Gross weight |
18 kg |
|
